Wincor Nixdorf BEETLE/20 Manuel de service télécharger pdf (Page 29)

System BIOS

01750201097 A BEETLE /mini-K – Operating Manual 24

System BIOS

This section describes Award BIOS™ Setup program built into the ROM BIOS.

The Setup program allows users to modify the basic system configuration. This

special information is then stored in battery-backed RAM so that it retains the

Setup information when the power is turned off.

The BIOS reads the system information contained in the CMOS and begins the

process of checking out the system and configuring it. When it finishes, the

BIOS will seek an operating system on one of the disks and then launch and turn

control over to the operating system.

The Setup program can be activated by pressing the <Del> key when the

following message appears briefly at the bottom of the screen during the POST

(Power On Self-Test).

Press DEL to enter SETUP.

Below is the menu displayed on entering the Setup program.

Phoenix – AwardBIOS CMOS Setup Utility

> Standard CMOS Features

> Advanced BIOS Features

> Frequency/Voltage Control

DMI Information

> Advanced Chipset Features Load Fail-Safe Defaults

> Integrated Peripherals Load Optimized Defaults

> Security Chip Configuration Set Supervisor Password

> Power Management Setup Set User Password

> PnP PCI Configurations Save & Exit Setup

> PC Health Status Exit Without Saving

ESC : Quit ↑ ↓ → ← : Select Line

F10 : Save & Exit Setup

1 2 ... 24 25 26 27 28 29 30 31 32 33

Pas de commentaire

Wincor Nixdorf BEETLE/20 Manuel de service Page 29