Wincor Nixdorf BEETLE/20 Manuel d'utilisateur télécharger pdf (Page 14)

8 BEETLE /iPRINT User Manual

Connecting the BEETLE /iPRINT

Follow the steps below in the order given when installing devices:

 Plug one end of the power cable of the power supply unit into the socket

(DC24V) of the BEETLE /iPRINT.

 Connect the monitor before you switch on your BEETLE /iPRINT.

 Plug the other end of the cable into the main power supply.

Always make sure that all power plugs from the grounded-contact

power sockets are unplugged.

Except for one USB connection on the front side of the BEETLE /iPRINT the

connectors are located on the rear side.

Take care that the plugs are firmly connected. Check this by slightly pulling

at the plug.

Basic Settings

Ex works, the BEETLE /iPRINT is configured to your order.

Your configuration must be subsequently adapted to support supplementary

devices such as scanners. For more information, contact the Wincor Nixdorf

International GmbH branch office responsible for your area.

DC24V LAN

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 47 48

Pas de commentaire

Wincor Nixdorf BEETLE/20 Manuel d'utilisateur Page 14