Wincor Nixdorf BEETLE AT COM Board Manuel d'utilisateur télécharger pdf (Page 16)

10 BEETLE /M-II plus (BOS) User Manual

Remove each of the feet.

Turn each of them to the position needed for the wall mounting, for example:

The minimum distances listed in the figure must be maintained; otherwise, a

sufficient ventilation of the equipment is not guaranteed.

The BEETLE /M-II plus (BOS) is designed for horizontal.

If you install the BEETLE /M-II plus (BOS) in vertical position, you have

attend to the following:

 Three breakable bore holes are located at the underside, which allow

the BEETLE /M-II plus (BOS) to be suspended by means of the screws.

 Mind the following minimum clearances also for vertical mounting to

ensure sufficient ventilation:

forward: 100 mm,

backward: 60 mm

sideways (left): 50 mm

 A surface made of nonflammable material (e.g. concrete or metal) must

be located underneath the vertically mounted power supply unit.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 51 52

Pas de commentaire

Wincor Nixdorf BEETLE AT COM Board Manuel d'utilisateur Page 16